Full-Width Rear Dormers in Cornwall
Our teams install full-width rear dormers throughout Cornwall, handling structure, weatherproofing, glazing and finish as one job with one point of contact.
Full-Width Rear Dormers — indicative geometry
Full-Width Rear Dormers for Cornwall homes
Cornwall is a mix of granite and rendered cottages, Victorian villas and post-war bungalows, and each of those wants a different dormer form — which is why we survey before quoting rather than pricing off a photograph.
A full-width rear dormer runs from party wall to party wall, squaring off the entire rear slope. On a standard terrace or semi it typically converts 12–18m² of crawl space into full-height room — enough for a double bedroom and an en-suite. Set back 200mm from the eaves and 500mm below the ridge, it usually falls inside permitted development on a house that has not been extended before.
Key specification
| Typical projection | 4.0m – 8.0m wide |
|---|---|
| Set-back | 200mm from eaves, 500mm below ridge |
| Structure | Steel ridge beam plus floor steels |
| Roof finish | GRP, EPDM or single-ply membrane |
Planning and building control in Cornwall
We run the permitted development test on your specific property: set-back from the eaves, height against the ridge, volume allowance and whether an Article 4 direction applies locally.
Building regulations approval is separate and always required. We submit the application, book the inspections around the programme and hand you the completion certificate at the end — the document a buyer's surveyor will ask to see.
Why homeowners in Cornwall use us
We only do dormers. That sounds like a limitation until you have watched a general builder improvise a back gutter on a wet Thursday.
Send us the address and roughly what you are hoping to gain, and we will come back with a realistic answer rather than an optimistic one.
Other dormer work in Cornwall
FAQs
Full-Width Rear Dormers in Cornwall — FAQs
Can a dormer include an en-suite?
Very often, yes — a full-width or L-shaped dormer usually has enough floor area for a bedroom plus a shower room. The practical constraints are getting soil and waste down to an existing stack, and whether the head height over the shower tray works. Both are settled at survey.
What happens to my existing loft insulation?
It comes out. Insulation at ceiling-joist level is in the wrong place once the loft is a room — the thermal line moves up to the new roof and dormer build-up. We remove and dispose of the old quilt and insulate the new envelope, which is also what makes the room comfortable to use in August.
How long does a dormer take to build?
A single box or flat roof dormer is typically three to five weeks on site. A full-width rear dormer runs five to eight weeks, and an L-shaped dormer on a terrace with an outrigger is closer to seven to ten. A complete dormer loft conversion including the staircase, services and finishes is usually eight to twelve weeks from scaffold up to sign-off.
Can you build a dormer on a bungalow?
Usually yes, and bungalows often give the best results because the spans are wide and there are no party walls. The deciding factor is ridge height: you generally want at least 2.6m from the top of the ceiling joists to the underside of the ridge. We measure this at survey before committing to anything.
Can I put a dormer on the front of my house?
Front-facing dormers are not covered by permitted development and always need a full planning application. Approval depends heavily on the street scene — planners look at whether other dormers already exist on the road, and at proportion, position and materials. Hipped and pitched forms are approved far more often than flat boxes on a front elevation.
Find out what your roof will take
A free measured survey in Cornwall tells you what is achievable, what it needs, and what it costs — before you commit to anything.