Cat Slide Dormers in Cornwall
We are a dormer specialist, not a general builder who occasionally does roofs — and across Cornwall that focus shows up in the detailing.
Cat Slide Dormers — indicative geometry
Cat Slide Dormers for Cornwall homes
Most of the dormer work we take on around Cornwall is on granite and rendered cottages, Victorian villas and post-war bungalows, where the ridge height and the position of the existing purlins set the limits.
A cat slide (or 'sweeping') dormer lets the main roof plane run on below the dormer sill, so the dormer appears to emerge from the roof rather than to be planted on it. It is a rural and cottage idiom, and it works beautifully on long, low roofs where a box dormer would look brutal. Detailing at the sill and the sweeping valley is the whole job.
Key specification
| Typical width | 1.2m – 3.0m |
|---|---|
| Sweep | Main roof continues below sill line |
| Roof finish | Plain tile, slate or pantile |
| Critical detail | Swept valley and sill flashing |
Planning and building control in Cornwall
Rear dormers on houses often sit inside permitted development, but the volume allowance is consumed by any previous loft or rear extension — so we check the planning history for the address before we say yes.
Building regulations approval is separate and always required. We submit the application, book the inspections around the programme and hand you the completion certificate at the end — the document a buyer's surveyor will ask to see.
Why homeowners in Cornwall use us
We would rather tell you at survey that your ridge height will not take what you want than take a deposit and find out in week three.
Send us the address and roughly what you are hoping to gain, and we will come back with a realistic answer rather than an optimistic one.
Other dormer work in Cornwall
FAQs
Cat Slide Dormers in Cornwall — FAQs
How wide can a dormer be?
Structurally, as wide as the roof — full-width rear dormers regularly run six to eight metres, carried on a steel ridge beam. The limits are usually planning volume allowances and the setbacks needed at eaves and ridge, rather than what can be built.
What guarantees do you provide?
Structural work carries a ten-year guarantee, GRP and EPDM flat roofing twenty years, windows ten years on frames and sealed units, and lead and zinc work is covered for workmanship for ten years. You also receive the building control completion certificate, which is the document that actually matters when you sell.
Can you build a dormer in winter?
Yes, with adjustments. Temporary weather protection over the scaffold lets structural work continue in most conditions. GRP roofing needs dry conditions above about 5°C to cure properly, so in a cold spell we either sequence it differently or specify EPDM, which is unaffected.
How much does a dormer window cost?
A single flat roof dormer typically runs from around £9,000 to £20,000 supplied and fitted, depending on width, cladding finish and access. A full-width rear dormer on a semi is usually £28,000 to £45,000, and a complete dormer loft conversion including stairs, insulation, plaster and building control sign-off is more commonly £40,000 to £70,000. Our online guide-price tool gives you an indicative range in about a minute.
Does a dormer need building regulations approval?
Yes, always — permitted development covers planning, not building control. A dormer needs approval for structure, thermal performance under Part L, fire escape and protected route under Part B, and stairs under Part K if a staircase is involved. We handle the application, the inspections and the completion certificate.
Find out what your roof will take
A free measured survey in Cornwall tells you what is achievable, what it needs, and what it costs — before you commit to anything.