Skip to content

Velux to Dormer Conversions in West Midlands

We design, build and weatherproof velux to dormer conversions for homeowners across West Midlands, working from first survey through to building control sign-off.

Free measured surveyA specialist visits, measures and tells you what the roof will and will not take.
Fixed written priceOne quotation covering structure, scaffold, weatherproofing, glazing and making good.
Building control managedWe submit, book the inspections and hand you the completion certificate.
Insured and guaranteed£5m public liability, ten-year structural and twenty-year flat roofing guarantees.
Nationwide coverageDirectly employed and vetted specialist teams across England, Wales, Scotland and Northern Ireland.

Velux to Dormer Conversions — indicative geometry

Velux to Dormer Conversions for West Midlands homes

Because West Midlands is largely interwar semis, post-war council-built estates and Victorian terraces around the older industrial cores, the roof pitches and span widths we meet are fairly predictable, and that makes feasibility a quick conversation rather than a guess.

Plenty of lofts were converted in the 1990s and 2000s with rooflights only, leaving a room with sloping ceilings you cannot put a wardrobe against. Cutting a dormer into an already-converted loft is a shorter job than starting from scratch — the floor, stair and services are already there — but it does need the existing structure checking before anything is opened up.

Key specification

Typical gain3m² – 8m² of full-height floor
PrerequisiteExisting floor structure verified
DisruptionRoom out of use 3–5 weeks
Roof finishGRP, EPDM or tile to suit
Indicative guide prices. Our online tool gives a realistic range in about a minute — pick your dormer type, width, finish and scope. Get an indicative price →

Planning and building control in West Midlands

Getting the consent route right at the start saves months. We establish whether it is permitted development, a lawful development certificate or a full application on the first visit.

Building regulations approval is separate and always required. We submit the application, book the inspections around the programme and hand you the completion certificate at the end — the document a buyer's surveyor will ask to see.

Why homeowners in West Midlands use us

The completion certificate is part of the deliverable, not an afterthought. It is the document that makes the space count when you come to sell.

Send us the address and roughly what you are hoping to gain, and we will come back with a realistic answer rather than an optimistic one.

Other dormer work in West Midlands

FAQs

Velux to Dormer Conversions in West Midlands — FAQs

Do I need planning permission for a dormer window?

Rear dormers on a house often fall under permitted development, provided the dormer is set at least 200mm back from the eaves, sits below the ridge line, uses materials similar in appearance to the existing house, and stays within the volume allowance — 40m³ for a terrace, 50m³ for a semi or detached. Front-facing dormers, flats and maisonettes, listed buildings, conservation areas and any property with an Article 4 direction all need a full planning application. We check the constraints on your specific address before we quote.

Will my roof be open to the weather?

No. The roof is only opened once the scaffold, temporary weather protection and materials are all on site, and the dormer is made weathertight — structure, deck, membrane and temporary glazing — before the crew leaves at the end of the opening-up phase. We do not open a roof on a Friday afternoon.

What is the best roof covering for a flat dormer?

GRP fibreglass and EPDM rubber are the two we specify most. GRP cures into a single seamless laminate with bonded trims and suits small tops with several upstands. EPDM is a one-piece membrane that copes better with movement on larger spans. Both carry twenty-year guarantees; mineral felt is cheaper but has a materially shorter life.

What insulation do dormers need?

Current building regulations want around 0.15–0.18 W/m²K for a new dormer roof and 0.18 W/m²K for the cheeks and front. In practice that is a warm-roof build-up using 100–150mm of PIR insulation above or between the structure, with a continuous vapour control layer on the warm side. Getting the VCL continuous matters more than the insulation thickness.

Can you match my existing roof tiles?

Usually. Most common clay and concrete profiles are still in production or available reclaimed, and we source a match at survey stage so you see it before work starts. Where a discontinued profile cannot be matched exactly, we normally recommend taking tiles from a less visible slope for the dormer and using the closest new match on the hidden elevation.

Read all frequently asked questions →

Find out what your roof will take

A free measured survey in West Midlands tells you what is achievable, what it needs, and what it costs — before you commit to anything.

Message us on WhatsApp
Call WhatsApp Get a quote