Pitched Roof Dormers in Cheshire
We design, build and weatherproof pitched roof dormers for homeowners across Cheshire, working from first survey through to building control sign-off.
Pitched Roof Dormers — indicative geometry
Pitched Roof Dormers for Cheshire homes
Most of the dormer work we take on around Cheshire is on Victorian and Edwardian terraces, interwar semi-detached houses and post-war bungalows, where the ridge height and the position of the existing purlins set the limits.
A pitched roof dormer carries its own small ridge and two slopes, tiled or slated to match the main roof. It sheds water the way the rest of the house does, ages the same way, and is very often the only form a conservation officer will accept on a front elevation. You lose a little internal height at the head compared with a flat top, and you gain a roofline that nobody questions.
Key specification
| Typical projection | 1.2m – 3.0m wide |
|---|---|
| Pitch | 35° – 45°, usually matched to main roof |
| Roof finish | Plain tile, pantile or natural slate |
| Flashing | Code 4/5 lead soakers and back gutter |
Planning and building control in Cheshire
Rear dormers on houses often sit inside permitted development, but the volume allowance is consumed by any previous loft or rear extension — so we check the planning history for the address before we say yes.
Building regulations approval is separate and always required. We submit the application, book the inspections around the programme and hand you the completion certificate at the end — the document a buyer's surveyor will ask to see.
Why homeowners in Cheshire use us
We would rather tell you at survey that your ridge height will not take what you want than take a deposit and find out in week three.
If you want to know what your roof will actually take, the survey is free and there is no obligation attached to it.
Other dormer work in Cheshire
FAQs
Pitched Roof Dormers in Cheshire — FAQs
What is the best roof covering for a flat dormer?
GRP fibreglass and EPDM rubber are the two we specify most. GRP cures into a single seamless laminate with bonded trims and suits small tops with several upstands. EPDM is a one-piece membrane that copes better with movement on larger spans. Both carry twenty-year guarantees; mineral felt is cheaper but has a materially shorter life.
What insulation do dormers need?
Current building regulations want around 0.15–0.18 W/m²K for a new dormer roof and 0.18 W/m²K for the cheeks and front. In practice that is a warm-roof build-up using 100–150mm of PIR insulation above or between the structure, with a continuous vapour control layer on the warm side. Getting the VCL continuous matters more than the insulation thickness.
Can you match my existing roof tiles?
Usually. Most common clay and concrete profiles are still in production or available reclaimed, and we source a match at survey stage so you see it before work starts. Where a discontinued profile cannot be matched exactly, we normally recommend taking tiles from a less visible slope for the dormer and using the closest new match on the hidden elevation.
Can you convert an existing Velux loft to a dormer?
Yes, and it is usually a shorter job than starting from scratch because the floor, staircase and services already exist. We verify the existing floor structure and any previous building control approval first, then cut and form the dormer into the finished room. Expect the room to be out of use for three to five weeks.
How disruptive is a dormer build?
Less than people expect, because most of the work happens above your ceilings and is reached from the scaffold. The noisy phases are opening up and installing steels, typically two to four days. Once the staircase is cut in there is dust and traffic through the house, and we sheet and protect the route for that period.
Find out what your roof will take
A free measured survey in Cheshire tells you what is achievable, what it needs, and what it costs — before you commit to anything.