Pitched Roof Dormers in Bristol
Our teams install pitched roof dormers throughout Bristol, handling structure, weatherproofing, glazing and finish as one job with one point of contact.
Pitched Roof Dormers — indicative geometry
Pitched Roof Dormers for Bristol homes
Most of the dormer work we take on around Bristol is on Victorian and Edwardian terraces, interwar semi-detached houses and post-war bungalows, where the ridge height and the position of the existing purlins set the limits.
A pitched roof dormer carries its own small ridge and two slopes, tiled or slated to match the main roof. It sheds water the way the rest of the house does, ages the same way, and is very often the only form a conservation officer will accept on a front elevation. You lose a little internal height at the head compared with a flat top, and you gain a roofline that nobody questions.
Key specification
| Typical projection | 1.2m – 3.0m wide |
|---|---|
| Pitch | 35° – 45°, usually matched to main roof |
| Roof finish | Plain tile, pantile or natural slate |
| Flashing | Code 4/5 lead soakers and back gutter |
Planning and building control in Bristol
Rear dormers on houses often sit inside permitted development, but the volume allowance is consumed by any previous loft or rear extension — so we check the planning history for the address before we say yes.
Building regulations approval is separate and always required. We submit the application, book the inspections around the programme and hand you the completion certificate at the end — the document a buyer's surveyor will ask to see.
Why homeowners in Bristol use us
We would rather tell you at survey that your ridge height will not take what you want than take a deposit and find out in week three.
Send us the address and roughly what you are hoping to gain, and we will come back with a realistic answer rather than an optimistic one.
Other dormer work in Bristol
FAQs
Pitched Roof Dormers in Bristol — FAQs
Can a dormer include an en-suite?
Very often, yes — a full-width or L-shaped dormer usually has enough floor area for a bedroom plus a shower room. The practical constraints are getting soil and waste down to an existing stack, and whether the head height over the shower tray works. Both are settled at survey.
What happens to my existing loft insulation?
It comes out. Insulation at ceiling-joist level is in the wrong place once the loft is a room — the thermal line moves up to the new roof and dormer build-up. We remove and dispose of the old quilt and insulate the new envelope, which is also what makes the room comfortable to use in August.
How long does a dormer take to build?
A single box or flat roof dormer is typically three to five weeks on site. A full-width rear dormer runs five to eight weeks, and an L-shaped dormer on a terrace with an outrigger is closer to seven to ten. A complete dormer loft conversion including the staircase, services and finishes is usually eight to twelve weeks from scaffold up to sign-off.
Can you build a dormer on a bungalow?
Usually yes, and bungalows often give the best results because the spans are wide and there are no party walls. The deciding factor is ridge height: you generally want at least 2.6m from the top of the ceiling joists to the underside of the ridge. We measure this at survey before committing to anything.
Can I put a dormer on the front of my house?
Front-facing dormers are not covered by permitted development and always need a full planning application. Approval depends heavily on the street scene — planners look at whether other dormers already exist on the road, and at proportion, position and materials. Hipped and pitched forms are approved far more often than flat boxes on a front elevation.
Find out what your roof will take
A free measured survey in Bristol tells you what is achievable, what it needs, and what it costs — before you commit to anything.