Lead & Zinc Dormer Roofing in Pembrokeshire
If you are weighing up lead & zinc dormer roofing in Pembrokeshire, we survey the roof, tell you what is actually achievable, and price it properly before anyone commits.
Lead & Zinc Dormer Roofing — indicative geometry
Lead & Zinc Dormer Roofing for Pembrokeshire homes
Most of the dormer work we take on around Pembrokeshire is on Victorian and Edwardian terraces, interwar semi-detached houses and post-war bungalows, where the ridge height and the position of the existing purlins set the limits.
Lead fails from thermal movement, not from age — which means bay sizes, code thickness and fixing centres decide whether a dormer roof lasts thirty years or three. We work to Lead Sheet Association guidance on every detail: welted bays, correct laps, chase depths and clip spacing. Standing-seam zinc gives a similar lifespan with a lighter, more contemporary line.
Key specification
| Lead codes | Code 4, 5 and 6 to LSA guidance |
|---|---|
| Bay sizes | Sized to code and orientation |
| Zinc | Standing seam, natural or pre-weathered |
| Substrate | Ventilated deck with separation layer |
Planning and building control in Pembrokeshire
Rear dormers on houses often sit inside permitted development, but the volume allowance is consumed by any previous loft or rear extension — so we check the planning history for the address before we say yes.
Building regulations approval is separate and always required. We submit the application, book the inspections around the programme and hand you the completion certificate at the end — the document a buyer's surveyor will ask to see.
Why homeowners in Pembrokeshire use us
We would rather tell you at survey that your ridge height will not take what you want than take a deposit and find out in week three.
The quickest route is a photograph of the rear elevation over WhatsApp — we can usually tell you what is feasible before anyone visits.
Other dormer work in Pembrokeshire
FAQs
Lead & Zinc Dormer Roofing in Pembrokeshire — FAQs
Will my roof be open to the weather?
No. The roof is only opened once the scaffold, temporary weather protection and materials are all on site, and the dormer is made weathertight — structure, deck, membrane and temporary glazing — before the crew leaves at the end of the opening-up phase. We do not open a roof on a Friday afternoon.
What is the best roof covering for a flat dormer?
GRP fibreglass and EPDM rubber are the two we specify most. GRP cures into a single seamless laminate with bonded trims and suits small tops with several upstands. EPDM is a one-piece membrane that copes better with movement on larger spans. Both carry twenty-year guarantees; mineral felt is cheaper but has a materially shorter life.
What insulation do dormers need?
Current building regulations want around 0.15–0.18 W/m²K for a new dormer roof and 0.18 W/m²K for the cheeks and front. In practice that is a warm-roof build-up using 100–150mm of PIR insulation above or between the structure, with a continuous vapour control layer on the warm side. Getting the VCL continuous matters more than the insulation thickness.
Can you match my existing roof tiles?
Usually. Most common clay and concrete profiles are still in production or available reclaimed, and we source a match at survey stage so you see it before work starts. Where a discontinued profile cannot be matched exactly, we normally recommend taking tiles from a less visible slope for the dormer and using the closest new match on the hidden elevation.
Can you convert an existing Velux loft to a dormer?
Yes, and it is usually a shorter job than starting from scratch because the floor, staircase and services already exist. We verify the existing floor structure and any previous building control approval first, then cut and form the dormer into the finished room. Expect the room to be out of use for three to five weeks.
Find out what your roof will take
A free measured survey in Pembrokeshire tells you what is achievable, what it needs, and what it costs — before you commit to anything.