Lead & Zinc Dormer Roofing in Cumbria
We are a dormer specialist, not a general builder who occasionally does roofs — and across Cumbria that focus shows up in the detailing.
Lead & Zinc Dormer Roofing — indicative geometry
Lead & Zinc Dormer Roofing for Cumbria homes
Most of the dormer work we take on around Cumbria is on slate and stone cottages, Victorian terraces and lakeland farmhouses, where the ridge height and the position of the existing purlins set the limits.
Lead fails from thermal movement, not from age — which means bay sizes, code thickness and fixing centres decide whether a dormer roof lasts thirty years or three. We work to Lead Sheet Association guidance on every detail: welted bays, correct laps, chase depths and clip spacing. Standing-seam zinc gives a similar lifespan with a lighter, more contemporary line.
Key specification
| Lead codes | Code 4, 5 and 6 to LSA guidance |
|---|---|
| Bay sizes | Sized to code and orientation |
| Zinc | Standing seam, natural or pre-weathered |
| Substrate | Ventilated deck with separation layer |
Planning and building control in Cumbria
Rear dormers on houses often sit inside permitted development, but the volume allowance is consumed by any previous loft or rear extension — so we check the planning history for the address before we say yes.
Building regulations approval is separate and always required. We submit the application, book the inspections around the programme and hand you the completion certificate at the end — the document a buyer's surveyor will ask to see.
Why homeowners in Cumbria use us
We would rather tell you at survey that your ridge height will not take what you want than take a deposit and find out in week three.
Send us the address and roughly what you are hoping to gain, and we will come back with a realistic answer rather than an optimistic one.
Other dormer work in Cumbria
FAQs
Lead & Zinc Dormer Roofing in Cumbria — FAQs
Does a dormer need building regulations approval?
Yes, always — permitted development covers planning, not building control. A dormer needs approval for structure, thermal performance under Part L, fire escape and protected route under Part B, and stairs under Part K if a staircase is involved. We handle the application, the inspections and the completion certificate.
Why is my dormer leaking?
In our experience the window itself is the cause less than a fifth of the time. Far more often it is the apron flashing at the dormer front, the lead soakers where the cheeks meet the roof slope, the back gutter behind a pitched dormer, or a split at an upstand in the flat covering. Water then tracks along a rafter and appears somewhere else entirely, which is why we trace the path before quoting.
Will a dormer add value to my house?
A properly built and signed-off dormer conversion adding a bedroom and bathroom typically returns a meaningful share of its cost in value, and more in areas where floor space is scarce. The building control completion certificate is what makes the space count as habitable floor area on a valuation — without it, surveyors will not include it.
Is scaffolding included in the price?
Yes. Every quotation we issue includes scaffold design, erection, weekly inspection, hire for the programme and dismantling. Scaffold appearing as an extra afterwards is one of the more common complaints about dormer work, so we price it in from the start.
How wide can a dormer be?
Structurally, as wide as the roof — full-width rear dormers regularly run six to eight metres, carried on a steel ridge beam. The limits are usually planning volume allowances and the setbacks needed at eaves and ridge, rather than what can be built.
Find out what your roof will take
A free measured survey in Cumbria tells you what is achievable, what it needs, and what it costs — before you commit to anything.