GRP Fibreglass Dormer Roofing in Lancashire
We are a dormer specialist, not a general builder who occasionally does roofs — and across Lancashire that focus shows up in the detailing.
GRP Fibreglass Dormer Roofing — indicative geometry
GRP Fibreglass Dormer Roofing for Lancashire homes
Most of the dormer work we take on around Lancashire is on Victorian and Edwardian terraces, interwar semi-detached houses and post-war bungalows, where the ridge height and the position of the existing purlins set the limits.
GRP is laid wet onto an 18mm OSB or ply deck and cures into one continuous laminate with the trims bonded in — there is no seam, no lap and no weld to fail. On a small flat dormer top with several upstands and a wall abutment, that seamlessness is worth a great deal. It needs dry weather and a temperature above about 5°C to lay properly.
Key specification
| Build-up | 18mm deck, CSM matting, polyester resin, topcoat |
|---|---|
| Trims | GRP edge, drip and wall trims bonded in |
| Design life | 20–25 years |
| Fall | 1:80 minimum |
Planning and building control in Lancashire
Rear dormers on houses often sit inside permitted development, but the volume allowance is consumed by any previous loft or rear extension — so we check the planning history for the address before we say yes.
Building regulations approval is separate and always required. We submit the application, book the inspections around the programme and hand you the completion certificate at the end — the document a buyer's surveyor will ask to see.
Why homeowners in Lancashire use us
We would rather tell you at survey that your ridge height will not take what you want than take a deposit and find out in week three.
If you want to know what your roof will actually take, the survey is free and there is no obligation attached to it.
Other dormer work in Lancashire
FAQs
GRP Fibreglass Dormer Roofing in Lancashire — FAQs
Will a dormer add value to my house?
A properly built and signed-off dormer conversion adding a bedroom and bathroom typically returns a meaningful share of its cost in value, and more in areas where floor space is scarce. The building control completion certificate is what makes the space count as habitable floor area on a valuation — without it, surveyors will not include it.
Is scaffolding included in the price?
Yes. Every quotation we issue includes scaffold design, erection, weekly inspection, hire for the programme and dismantling. Scaffold appearing as an extra afterwards is one of the more common complaints about dormer work, so we price it in from the start.
How wide can a dormer be?
Structurally, as wide as the roof — full-width rear dormers regularly run six to eight metres, carried on a steel ridge beam. The limits are usually planning volume allowances and the setbacks needed at eaves and ridge, rather than what can be built.
What guarantees do you provide?
Structural work carries a ten-year guarantee, GRP and EPDM flat roofing twenty years, windows ten years on frames and sealed units, and lead and zinc work is covered for workmanship for ten years. You also receive the building control completion certificate, which is the document that actually matters when you sell.
Can you build a dormer in winter?
Yes, with adjustments. Temporary weather protection over the scaffold lets structural work continue in most conditions. GRP roofing needs dry conditions above about 5°C to cure properly, so in a cold spell we either sequence it differently or specify EPDM, which is unaffected.
Find out what your roof will take
A free measured survey in Lancashire tells you what is achievable, what it needs, and what it costs — before you commit to anything.