Full-Width Rear Dormers in Herefordshire
If you are weighing up full-width rear dormers in Herefordshire, we survey the roof, tell you what is actually achievable, and price it properly before anyone commits.
Full-Width Rear Dormers — indicative geometry
Full-Width Rear Dormers for Herefordshire homes
Herefordshire is a mix of Victorian and Edwardian terraces, interwar semi-detached houses and post-war bungalows, and each of those wants a different dormer form — which is why we survey before quoting rather than pricing off a photograph.
A full-width rear dormer runs from party wall to party wall, squaring off the entire rear slope. On a standard terrace or semi it typically converts 12–18m² of crawl space into full-height room — enough for a double bedroom and an en-suite. Set back 200mm from the eaves and 500mm below the ridge, it usually falls inside permitted development on a house that has not been extended before.
Key specification
| Typical projection | 4.0m – 8.0m wide |
|---|---|
| Set-back | 200mm from eaves, 500mm below ridge |
| Structure | Steel ridge beam plus floor steels |
| Roof finish | GRP, EPDM or single-ply membrane |
Planning and building control in Herefordshire
We run the permitted development test on your specific property: set-back from the eaves, height against the ridge, volume allowance and whether an Article 4 direction applies locally.
Building regulations approval is separate and always required. We submit the application, book the inspections around the programme and hand you the completion certificate at the end — the document a buyer's surveyor will ask to see.
Why homeowners in Herefordshire use us
We only do dormers. That sounds like a limitation until you have watched a general builder improvise a back gutter on a wet Thursday.
The quickest route is a photograph of the rear elevation over WhatsApp — we can usually tell you what is feasible before anyone visits.
Other dormer work in Herefordshire
- GRP Fibreglass Dormer Roofing in Herefordshire
- Flat Roof Dormers in Herefordshire
- Hipped Roof Dormers in Herefordshire
- Box Dormers in Herefordshire
- Dormer Loft Conversions in Herefordshire
- Dormer Window Installation in Herefordshire
- Timber Dormer Windows in Herefordshire
- Conservation Dormer Windows in Herefordshire
FAQs
Full-Width Rear Dormers in Herefordshire — FAQs
Will my roof be open to the weather?
No. The roof is only opened once the scaffold, temporary weather protection and materials are all on site, and the dormer is made weathertight — structure, deck, membrane and temporary glazing — before the crew leaves at the end of the opening-up phase. We do not open a roof on a Friday afternoon.
What is the best roof covering for a flat dormer?
GRP fibreglass and EPDM rubber are the two we specify most. GRP cures into a single seamless laminate with bonded trims and suits small tops with several upstands. EPDM is a one-piece membrane that copes better with movement on larger spans. Both carry twenty-year guarantees; mineral felt is cheaper but has a materially shorter life.
What insulation do dormers need?
Current building regulations want around 0.15–0.18 W/m²K for a new dormer roof and 0.18 W/m²K for the cheeks and front. In practice that is a warm-roof build-up using 100–150mm of PIR insulation above or between the structure, with a continuous vapour control layer on the warm side. Getting the VCL continuous matters more than the insulation thickness.
Can you match my existing roof tiles?
Usually. Most common clay and concrete profiles are still in production or available reclaimed, and we source a match at survey stage so you see it before work starts. Where a discontinued profile cannot be matched exactly, we normally recommend taking tiles from a less visible slope for the dormer and using the closest new match on the hidden elevation.
Can you convert an existing Velux loft to a dormer?
Yes, and it is usually a shorter job than starting from scratch because the floor, staircase and services already exist. We verify the existing floor structure and any previous building control approval first, then cut and form the dormer into the finished room. Expect the room to be out of use for three to five weeks.
Find out what your roof will take
A free measured survey in Herefordshire tells you what is achievable, what it needs, and what it costs — before you commit to anything.