Flat Roof Dormers in West Yorkshire
West Yorkshire homeowners come to us for flat roof dormers that are properly detailed at the junctions — because that is where dormers succeed or fail.
Flat Roof Dormers — indicative geometry
Flat Roof Dormers for West Yorkshire homes
Most of the dormer work we take on around West Yorkshire is on gritstone and brick terraces, back-to-backs and generous interwar semis, where the ridge height and the position of the existing purlins set the limits.
A flat roof dormer projects square from the roof slope with a shallow-fall flat top, usually finished in GRP fibreglass, EPDM or single-ply membrane. Because the walls are vertical and the ceiling is level, you keep full standing height right up to the window — which is why it is the default choice on rear elevations where planning is under permitted development.
Key specification
| Typical projection | 1.8m – 6.0m wide |
|---|---|
| Roof fall | 1:80 minimum to the rear |
| Roof finish | GRP, EPDM or single-ply membrane |
| Cheek finish | Tile-hung, GRP, lead, zinc or timber |
Planning and building control in West Yorkshire
Rear dormers on houses often sit inside permitted development, but the volume allowance is consumed by any previous loft or rear extension — so we check the planning history for the address before we say yes.
Building regulations approval is separate and always required. We submit the application, book the inspections around the programme and hand you the completion certificate at the end — the document a buyer's surveyor will ask to see.
Why homeowners in West Yorkshire use us
We would rather tell you at survey that your ridge height will not take what you want than take a deposit and find out in week three.
The quickest route is a photograph of the rear elevation over WhatsApp — we can usually tell you what is feasible before anyone visits.
Other dormer work in West Yorkshire
FAQs
Flat Roof Dormers in West Yorkshire — FAQs
Why is my dormer leaking?
In our experience the window itself is the cause less than a fifth of the time. Far more often it is the apron flashing at the dormer front, the lead soakers where the cheeks meet the roof slope, the back gutter behind a pitched dormer, or a split at an upstand in the flat covering. Water then tracks along a rafter and appears somewhere else entirely, which is why we trace the path before quoting.
Will a dormer add value to my house?
A properly built and signed-off dormer conversion adding a bedroom and bathroom typically returns a meaningful share of its cost in value, and more in areas where floor space is scarce. The building control completion certificate is what makes the space count as habitable floor area on a valuation — without it, surveyors will not include it.
Is scaffolding included in the price?
Yes. Every quotation we issue includes scaffold design, erection, weekly inspection, hire for the programme and dismantling. Scaffold appearing as an extra afterwards is one of the more common complaints about dormer work, so we price it in from the start.
How wide can a dormer be?
Structurally, as wide as the roof — full-width rear dormers regularly run six to eight metres, carried on a steel ridge beam. The limits are usually planning volume allowances and the setbacks needed at eaves and ridge, rather than what can be built.
What guarantees do you provide?
Structural work carries a ten-year guarantee, GRP and EPDM flat roofing twenty years, windows ten years on frames and sealed units, and lead and zinc work is covered for workmanship for ten years. You also receive the building control completion certificate, which is the document that actually matters when you sell.
Find out what your roof will take
A free measured survey in West Yorkshire tells you what is achievable, what it needs, and what it costs — before you commit to anything.