Flat Roof Dormers in Edinburgh and the Lothians
We design, build and weatherproof flat roof dormers for homeowners across Edinburgh and the Lothians, working from first survey through to building control sign-off.
Flat Roof Dormers — indicative geometry
Flat Roof Dormers for Edinburgh and the Lothians homes
Most of the dormer work we take on around Edinburgh and the Lothians is on Victorian and Edwardian terraces, interwar semi-detached houses and post-war bungalows, where the ridge height and the position of the existing purlins set the limits.
A flat roof dormer projects square from the roof slope with a shallow-fall flat top, usually finished in GRP fibreglass, EPDM or single-ply membrane. Because the walls are vertical and the ceiling is level, you keep full standing height right up to the window — which is why it is the default choice on rear elevations where planning is under permitted development.
Key specification
| Typical projection | 1.8m – 6.0m wide |
|---|---|
| Roof fall | 1:80 minimum to the rear |
| Roof finish | GRP, EPDM or single-ply membrane |
| Cheek finish | Tile-hung, GRP, lead, zinc or timber |
Planning and building control in Edinburgh and the Lothians
Rear dormers on houses often sit inside permitted development, but the volume allowance is consumed by any previous loft or rear extension — so we check the planning history for the address before we say yes.
Building regulations approval is separate and always required. We submit the application, book the inspections around the programme and hand you the completion certificate at the end — the document a buyer's surveyor will ask to see.
Why homeowners in Edinburgh and the Lothians use us
We would rather tell you at survey that your ridge height will not take what you want than take a deposit and find out in week three.
Send us the address and roughly what you are hoping to gain, and we will come back with a realistic answer rather than an optimistic one.
Other dormer work in Edinburgh and the Lothians
- Dormer Window Replacement in Edinburgh and the Lothians
- Aluminium Dormer Windows in Edinburgh and the Lothians
- Dormer Cladding in Edinburgh and the Lothians
- Dormer Window Repairs in Edinburgh and the Lothians
- Hipped Roof Dormers in Edinburgh and the Lothians
- L-Shaped Dormers in Edinburgh and the Lothians
- Cat Slide Dormers in Edinburgh and the Lothians
- Velux to Dormer Conversions in Edinburgh and the Lothians
FAQs
Flat Roof Dormers in Edinburgh and the Lothians — FAQs
Do I need planning permission for a dormer window?
Rear dormers on a house often fall under permitted development, provided the dormer is set at least 200mm back from the eaves, sits below the ridge line, uses materials similar in appearance to the existing house, and stays within the volume allowance — 40m³ for a terrace, 50m³ for a semi or detached. Front-facing dormers, flats and maisonettes, listed buildings, conservation areas and any property with an Article 4 direction all need a full planning application. We check the constraints on your specific address before we quote.
Will my roof be open to the weather?
No. The roof is only opened once the scaffold, temporary weather protection and materials are all on site, and the dormer is made weathertight — structure, deck, membrane and temporary glazing — before the crew leaves at the end of the opening-up phase. We do not open a roof on a Friday afternoon.
What is the best roof covering for a flat dormer?
GRP fibreglass and EPDM rubber are the two we specify most. GRP cures into a single seamless laminate with bonded trims and suits small tops with several upstands. EPDM is a one-piece membrane that copes better with movement on larger spans. Both carry twenty-year guarantees; mineral felt is cheaper but has a materially shorter life.
What insulation do dormers need?
Current building regulations want around 0.15–0.18 W/m²K for a new dormer roof and 0.18 W/m²K for the cheeks and front. In practice that is a warm-roof build-up using 100–150mm of PIR insulation above or between the structure, with a continuous vapour control layer on the warm side. Getting the VCL continuous matters more than the insulation thickness.
Can you match my existing roof tiles?
Usually. Most common clay and concrete profiles are still in production or available reclaimed, and we source a match at survey stage so you see it before work starts. Where a discontinued profile cannot be matched exactly, we normally recommend taking tiles from a less visible slope for the dormer and using the closest new match on the hidden elevation.
Find out what your roof will take
A free measured survey in Edinburgh and the Lothians tells you what is achievable, what it needs, and what it costs — before you commit to anything.