Dormer Window Replacement in Highland and Moray
We design, build and weatherproof dormer window replacement for homeowners across Highland and Moray, working from first survey through to building control sign-off.
Dormer Window Replacement — indicative geometry
Dormer Window Replacement for Highland and Moray homes
Highland and Moray is a mix of Victorian and Edwardian terraces, interwar semi-detached houses and post-war bungalows, and each of those wants a different dormer form — which is why we survey before quoting rather than pricing off a photograph.
Most dormer windows fail long before the dormer does. Rotten timber sills, blown double-glazed units, seized hinges and perished seals are all replaceable in a day or two without disturbing the cheeks or roof. We survey the surrounding timber first — there is no point putting a new frame into a rotten sub-sill, and that is where a lot of cheap replacements go wrong.
Key specification
| Typical duration | 1–2 days per dormer |
|---|---|
| Scaffolding | Tower or scaffold depending on height |
| Sub-sill check | Timber probed and replaced if soft |
| Glazing upgrade | 1.2 W/m²K or better |
Planning and building control in Highland and Moray
We run the permitted development test on your specific property: set-back from the eaves, height against the ridge, volume allowance and whether an Article 4 direction applies locally.
Building regulations approval is separate and always required. We submit the application, book the inspections around the programme and hand you the completion certificate at the end — the document a buyer's surveyor will ask to see.
Why homeowners in Highland and Moray use us
We only do dormers. That sounds like a limitation until you have watched a general builder improvise a back gutter on a wet Thursday.
Send us the address and roughly what you are hoping to gain, and we will come back with a realistic answer rather than an optimistic one.
Other dormer work in Highland and Moray
- Hipped Roof Dormers in Highland and Moray
- L-Shaped Dormers in Highland and Moray
- Cat Slide Dormers in Highland and Moray
- Velux to Dormer Conversions in Highland and Moray
- Timber Dormer Windows in Highland and Moray
- Conservation Dormer Windows in Highland and Moray
- Lead & Zinc Dormer Roofing in Highland and Moray
- Pitched Roof Dormers in Highland and Moray
FAQs
Dormer Window Replacement in Highland and Moray — FAQs
Do I need planning permission for a dormer window?
Rear dormers on a house often fall under permitted development, provided the dormer is set at least 200mm back from the eaves, sits below the ridge line, uses materials similar in appearance to the existing house, and stays within the volume allowance — 40m³ for a terrace, 50m³ for a semi or detached. Front-facing dormers, flats and maisonettes, listed buildings, conservation areas and any property with an Article 4 direction all need a full planning application. We check the constraints on your specific address before we quote.
Will my roof be open to the weather?
No. The roof is only opened once the scaffold, temporary weather protection and materials are all on site, and the dormer is made weathertight — structure, deck, membrane and temporary glazing — before the crew leaves at the end of the opening-up phase. We do not open a roof on a Friday afternoon.
What is the best roof covering for a flat dormer?
GRP fibreglass and EPDM rubber are the two we specify most. GRP cures into a single seamless laminate with bonded trims and suits small tops with several upstands. EPDM is a one-piece membrane that copes better with movement on larger spans. Both carry twenty-year guarantees; mineral felt is cheaper but has a materially shorter life.
What insulation do dormers need?
Current building regulations want around 0.15–0.18 W/m²K for a new dormer roof and 0.18 W/m²K for the cheeks and front. In practice that is a warm-roof build-up using 100–150mm of PIR insulation above or between the structure, with a continuous vapour control layer on the warm side. Getting the VCL continuous matters more than the insulation thickness.
Can you match my existing roof tiles?
Usually. Most common clay and concrete profiles are still in production or available reclaimed, and we source a match at survey stage so you see it before work starts. Where a discontinued profile cannot be matched exactly, we normally recommend taking tiles from a less visible slope for the dormer and using the closest new match on the hidden elevation.
Find out what your roof will take
A free measured survey in Highland and Moray tells you what is achievable, what it needs, and what it costs — before you commit to anything.