Cat Slide Dormers in Derbyshire
We design, build and weatherproof cat slide dormers for homeowners across Derbyshire, working from first survey through to building control sign-off.
Cat Slide Dormers — indicative geometry
Cat Slide Dormers for Derbyshire homes
Most of the dormer work we take on around Derbyshire is on Victorian and Edwardian terraces, interwar semi-detached houses and post-war bungalows, where the ridge height and the position of the existing purlins set the limits.
A cat slide (or 'sweeping') dormer lets the main roof plane run on below the dormer sill, so the dormer appears to emerge from the roof rather than to be planted on it. It is a rural and cottage idiom, and it works beautifully on long, low roofs where a box dormer would look brutal. Detailing at the sill and the sweeping valley is the whole job.
Key specification
| Typical width | 1.2m – 3.0m |
|---|---|
| Sweep | Main roof continues below sill line |
| Roof finish | Plain tile, slate or pantile |
| Critical detail | Swept valley and sill flashing |
Planning and building control in Derbyshire
Rear dormers on houses often sit inside permitted development, but the volume allowance is consumed by any previous loft or rear extension — so we check the planning history for the address before we say yes.
Building regulations approval is separate and always required. We submit the application, book the inspections around the programme and hand you the completion certificate at the end — the document a buyer's surveyor will ask to see.
Why homeowners in Derbyshire use us
We would rather tell you at survey that your ridge height will not take what you want than take a deposit and find out in week three.
If you want to know what your roof will actually take, the survey is free and there is no obligation attached to it.
Other dormer work in Derbyshire
FAQs
Cat Slide Dormers in Derbyshire — FAQs
What is the best roof covering for a flat dormer?
GRP fibreglass and EPDM rubber are the two we specify most. GRP cures into a single seamless laminate with bonded trims and suits small tops with several upstands. EPDM is a one-piece membrane that copes better with movement on larger spans. Both carry twenty-year guarantees; mineral felt is cheaper but has a materially shorter life.
What insulation do dormers need?
Current building regulations want around 0.15–0.18 W/m²K for a new dormer roof and 0.18 W/m²K for the cheeks and front. In practice that is a warm-roof build-up using 100–150mm of PIR insulation above or between the structure, with a continuous vapour control layer on the warm side. Getting the VCL continuous matters more than the insulation thickness.
Can you match my existing roof tiles?
Usually. Most common clay and concrete profiles are still in production or available reclaimed, and we source a match at survey stage so you see it before work starts. Where a discontinued profile cannot be matched exactly, we normally recommend taking tiles from a less visible slope for the dormer and using the closest new match on the hidden elevation.
Can you convert an existing Velux loft to a dormer?
Yes, and it is usually a shorter job than starting from scratch because the floor, staircase and services already exist. We verify the existing floor structure and any previous building control approval first, then cut and form the dormer into the finished room. Expect the room to be out of use for three to five weeks.
How disruptive is a dormer build?
Less than people expect, because most of the work happens above your ceilings and is reached from the scaffold. The noisy phases are opening up and installing steels, typically two to four days. Once the staircase is cut in there is dust and traffic through the house, and we sheet and protect the route for that period.
Find out what your roof will take
A free measured survey in Derbyshire tells you what is achievable, what it needs, and what it costs — before you commit to anything.