Dormer windows in Kettering

GRP fibreglass and EPDM rubber are the two we specify most. GRP cures into a single seamless laminate with bonded trims and suits small tops with several upstands. EPDM is a one-piece membrane that copes better with movement on larger spans. Both carry twenty-year guarantees; mineral felt is cheaper but has a materially shorter life.

Front-facing dormers are not covered by permitted development and always need a full planning application. Approval depends heavily on the street scene — planners look at whether other dormers already exist on the road, and at proportion, position and materials. Hipped and pitched forms are approved far more often than flat boxes on a front elevation.

A properly built and signed-off dormer conversion adding a bedroom and bathroom typically returns a meaningful share of its cost in value, and more in areas where floor space is scarce. The building control completion certificate is what makes the space count as habitable floor area on a valuation — without it, surveyors will not include it.

Usually. Most common clay and concrete profiles are still in production or available reclaimed, and we source a match at survey stage so you see it before work starts. Where a discontinued profile cannot be matched exactly, we normally recommend taking tiles from a less visible slope for the dormer and using the closest new match on the hidden elevation.

A rooflight sits flush in the roof slope and gives you light without any extra height — you still have a sloping ceiling. A dormer projects out from the roof and creates vertical walls with a level ceiling behind them, so you gain genuinely usable standing space and floor area, not just daylight.

Structurally, as wide as the roof — full-width rear dormers regularly run six to eight metres, carried on a steel ridge beam. The limits are usually planning volume allowances and the setbacks needed at eaves and ridge, rather than what can be built.